Welcome to the SeeMeCNC Community

Sent G29 to the printer and the print head crashed into the bed as before then everything freezes up and I have to cut the power to the printer to reboot. When I try it again it seems to calibrate normally and the printer prints fine. I just don't think it should be doing this. I will post a video ...

SO...I take it that I will need to download the OctoPrint SW and somehow through that interface "send" a G29 command to the printer (which I assume at this moment is connected via USB) then follow the instructions in OctoPrint to install the plugin? Is that it? Will I need to re install the firmware ...

FW date is 20161209. FW version is 0.92.2 The script is as follows: ; Rostock Max v2/v3 Delta Auotcalibration Script G69 S2 ;Endstop Calibration M117 ENDSTOPS CALIBRATED G68 ;Horizontal Radius Calibration M117 HORIZONTAL RADIUS CALIBRATED G30 S2 ;Z height calibration M117 Z Height Calibrated G4 S2 ...

I plan on doing the same. It looks like all you need to do is find an innovative way to mount the accelerometer board onto the E3D V6. I do want to increase the temperature capability high enough to print Ultem material at 350C so I plan on converting the thermistor to a thermocouple. Anyone have ...

I have had a few instances of the hot end crashing onto the bed plate during the V3 probing G code execution. Instead of gently poking the bed plate like normal it pushes so hard that the entire hot end tips up on one ball socket nearly togging the other two. Sometimes when this happens the Cal ...