Well I'm printing xt-cf20 so there is a need for higher bed temps. I got the HB dialed in, holding 100c with some pid tuning.geneb wrote:FYI, there's zero reason to need 100C on a heated bed.
g.
Search found 2 matches
- Tue Jan 24, 2017 11:03 am
- Forum: New Member introduction
- Topic: Greetings from the PNW
- Replies: 10
- Views: 10192
Re: Greetings from the PNW
- Mon Jan 23, 2017 8:06 pm
- Forum: New Member introduction
- Topic: Greetings from the PNW
- Replies: 10
- Views: 10192
Greetings from the PNW
Got my V3 over the holidays, diy kit. Build went without hitch, hot end working just fine, heated bed not so well, after trouble shooting with tech we determined the bed was defective, second bed was received, works much better but still not warming up to my desired temp 100c.