Welcome to the SeeMeCNC Community

Figured out the issue finally. I changed the effector to one that put the motor and extruder right below. I did lose some height but there's no more wobble. The one I had on before had the motor sitting above and the arms were farther out. This is the current effector with dual fans. https://www ...

I have the the speeds down already. The motor motor rocks slightly on certain moves. With circles the ringing shows the most. On other prints not really a issue. Weird indeed.

Ok so I changed out the power supply from the atx to a 12v 20a regulated supply and the heated bed heats up pretty quickly. I've also switched the heater wires to the noodle like silicone wire. The ringing is still there even with .9 titan aero and new ball cup arm upgrade. From the looks of it when ...

In the process of upgrading will report back once complete.

I've dialed back the flow a bit to 95 percent. The heated bed can get to about 95 96 but I can't get it to go any higher. I changed my heated bed wiring to 10 gauge as I had the infamous terminal block melting. I have cooling enabled, some parts would deform with abs. I've never used matter control ...

I forgot that print was in abs. I was under the impression that I didn't have to do rafts and brims with pei. I do have the berd air max and it was on partially. My bed is maxing out at 95.

Hello all. Just recently upgraded my rostock max v2 with a titan aero , pei bed and ballcup arms. My prints thus far have improved but I'm stilling having a issue with 1 corner lifting on abs and corners not as sharp as they should be. Also there seems to be slight ringing. Can anyone chime in on ...

I'm having issues using repetier host. It works when first connected but after a while it just stops responding to controls and takes a while to actually respond after a long time. Changed cache ,various settings and usb cable still no go.

I'm having issues with connectivity repetier keeps timing out not sure what's going on. All parts stock. I just printed the peek fan on another printer.

Hello all just recently acquired a second hand rostock max 2 and figured now is a good time to join the forum as a lot of this is rather new and my first delta. Hope to learn a lot. My name is Brandon or bj I'm a tinkerer, engineer and much more. Looking forward to chatting with you guys.