Welcome to the SeeMeCNC Community

If you have a very large discrepancy in heights at the center and edge of the build surface, multiple mm's. The odds are you have differing steps per mm set for X Y and Z in the firmware and the EEPROM, the settings MUST match. If the disparity is small and they match then a small adjustment to ...

I'm having an issue with the Repetier firmware that I can't figure out. When leveling I end up with a height of 363.2 at each of the columns, but at the center it takes 368.2 to reach the bed. I didn't have this issue with the Marlin firmware and as far as I can tell I have the critical parameters ...