Welcome to the SeeMeCNC Community

When trying to test the connector with the multimeter probes, are the two metal contacts visible on the opposite side of the connector's clip sufficient for getting the reading? If so I am not getting a reading. I then checked the soldered leads on the HE280 PCB and also had no reading. This could ...

[img]https://c1.staticflickr.com/5/4232/35128457622_64e703f846.jpg[/img] (A photo with more contrast showing the arrow) That was the very same "resource diagram", I poorly described :lol: , that I double checked. With the thermistor better soldered would it be wise to try and "PID Tune the Hot End ...

[img]https://c1.staticflickr.com/5/4232/34885487780_09c59abec2_n.jpg[/img] [img]https://c1.staticflickr.com/5/4230/35232544046_765be012aa_n.jpg[/img] Comparing to the resource diagram, I believe it's all wired in correctly. Even gave the wires a little tug to make sure they were in. Checked the ...

When turned on it stated 111, rapidly rose, and has gotten to and fluctuates from 176-178 in varying increments (it did make it up to 190 toward the end of typing this post). This is standalone, with no connection to a computer.

Using MatterControl if I attempt to start a print and the nozzle temperature is above the temperature for the filament in the print operation it remains nearly at its current temperature. Ex: the LCD and Mattercontrol display a nozzle temp of 227. I start a print via MatterControl and it diplays ...

M119 doesn't change anything. It just prints the endstop states to the console. I don't use it often enough to remember the convention, but the states are High or Low and they should all be the same when the endstops are not triggered and reverse when the corresponding endstop is triggered. Fe ...

Use the gcode console to pass it an M119. An open on the endstop will cause that axis to think the endstop is triggered and it may not move or move only subtly. Just to rule out that possibility... Ran it through and it seems to be acting the same Just a note of printer behavior: When homing- the X ...

Recently was very fortunate and won a H2 Delta Hacker kit. While I do own two Robo3d R1+ machines, this is my first 3d printer kit. I have it all built and the Repetier firmware loaded into the mini-RAMBo to the best of my ability. While everything else appears to be working I have found that my Z ...