Kisslicer have been relatively good quality ~
However, there is still a gap surface.
In addition, aspects of the ear is still not satisfied.
The temperature of the hot end is too high?
Search found 6 matches
- Thu May 23, 2013 9:48 am
- Forum: Cura
- Topic: Cura slice problem ~ ~
- Replies: 7
- Views: 7601
Re: Cura slice problem ~ ~
Hi~All
Kisslicer have been relatively good quality ~
However, there is still a gap surface.
In addition, aspects of the ear is still not satisfied.
The temperature of the hot end is too high?
Kisslicer have been relatively good quality ~
However, there is still a gap surface.
In addition, aspects of the ear is still not satisfied.
The temperature of the hot end is too high?
- Mon May 20, 2013 9:37 am
- Forum: Cura
- Topic: Cura slice problem ~ ~
- Replies: 7
- Views: 7601
Re: Cura slice problem ~ ~
Thank you!!
I check again ~
I hope hurry to solve those problems ~
I check again ~
I hope hurry to solve those problems ~
- Mon May 20, 2013 6:05 am
- Forum: Cura
- Topic: Cura slice problem ~ ~
- Replies: 7
- Views: 7601
Re: Cura slice problem ~ ~
Hi ~ all
Is there anyone like me have this problem?
Is there any ways to improve it?
Is there anyone like me have this problem?
Is there any ways to improve it?
- Sat May 18, 2013 3:50 am
- Forum: Cura
- Topic: Cura slice problem ~ ~
- Replies: 7
- Views: 7601
Cura slice problem ~ ~
The cura path odd, the starting point and end point of the path is not in the same position. 
- Thu Apr 04, 2013 12:18 am
- Forum: New Member introduction
- Topic: Hello From TAIWAN
- Replies: 3
- Views: 3225
Re: Hello From TAIWAN
Thank you very much cambo3d, two problems are solved!
before hot-end is not heated to 200 degrees the extruder will not take any action!!
before hot-end is not heated to 200 degrees the extruder will not take any action!!
- Wed Apr 03, 2013 10:38 am
- Forum: New Member introduction
- Topic: Hello From TAIWAN
- Replies: 3
- Views: 3225
Hello From TAIWAN
Hello From TAIWAN (English is not my native language so there will be spelling errors or grammar errors, please bear with me.) Hi everybody, After 2 months of assembly, and correction of X, Y, Z axis is finally completed. Now there is a problem, and did not respond in the extruder. Extruder how to ...