Welcome to the SeeMeCNC Community

Update: I did some more googling and found this thread with the exact same problem: http://forum.seemecnc.com/viewtopic.php?t=4681 Turns out low speed SD cards and cards that are too high in GB storage will cause this. Interesting that this problem only started occurring when I switched to Cura with ...

Ok, I see. So Im using Matter Control to do any g-code work like calibrating the extruder and altering the PID's. In that case, I dont need Repetier Host, right?

Any ideas out there as to why this is happening?

All I'm doing is saving the file to sd card from cura and printing. Is there something else I'm missing?

Side note: I don't even have repetier host installed. Should I be using it somehow with Cura?

Hi all, I'm having an intermittent problem with my RMV2 after switching to Cura. 3 times now it has stopped either at the end of a print or a few layers short, and doesn't home. The hotend just sits there on the print and melts the plastic. It happens with short and tall prints. I've attached my ...