Welcome to the SeeMeCNC Community

Did those mounts, as well as reapplied my PEI sheet to my glass bed and used some 800 grit sandpaper to lightly sand the surface and im finally getting a good normal deviation. Also had some random line in my config that someone else on facebook suggested to remove and fixed my odd printing quality ...

That looks much better than mine. I will try the mounts once my buddy is able to print them for me, and use new fsr's i know my silicone pads are not exact center of the fsr, just slightly off to one side or another on all 3, so that could be whats causing most of my problems. will hopefully try it ...

I had removed the FSR triggers with a razor and reapplied them a different way, then had to do it a second time after that. So some sort of binding is probable, and could also be not triggering right cause of all the bunched up glue under the trigger. Ill try having a buddy print out the FSR holder ...

Tried doing the z stepping to some value, but doing it at .10 increments i couldnt find any decent value, it would just be normal height off the bed on the low spots then be very high on the rest and would basically just drip to the bed and not adhere and just drag the filament around till it was ...

ill have to try that tomorrow for the baby steps. and yes ive setup the z height for it, but it seems to not change anything. ive also ordered new fsr triggers and silicone pads hoping that maybe ive made it false trigger because ive removed 1 set of pads and the triggers with a razor (carefully ...

did m665 /m666 and updated the config.g file and tried another print. It was pressing down on the bed to the point of setting off all of the fsrs. i had z baby step it up 2mm and it was still 1/3 of the print hitting the bed and the other 2/3 was high enough off the bed so as to cause the stringing ...

Still running into the same problems even with new fsr plate and onyx. It just seems to be high on one side then low on the other side of the print. Ive got some weights ill try to dial it in more as for how much force is required to set off each trigger. In hopes i can give better information. I ...

bad bed adhesion and stringing. As for how sensitive one feels like it triggers alot easier then the other 2, but not by much. ive also got the FSR's and plate setup this way. Silicone Pad> FSR Sensor > Silicone Pad >Trick Laser plate > Onyx Bed > Glass Bed > m3 adhesive > Pei Sheet. Ive also got 6 ...

So i need some help, ive been asking people on a few facebook groups and a buddy of mine and so far no such luck. I may just be doomed to never print again. So ill give a brief history. I bought a used Rostock Max v3 it was all stock and printed fine, no problems. But I was getting my feet wet and ...