Welcome to the SeeMeCNC Community

hi, i accidentally short the heating cartridge(red thick wire) to heating block try to change nozzle end it went dead:((, no lite.... can that short the board... fuse check ok and i got 12v to connector, any ideas ? ty

hi ty for your time... problem solve ,my fault ,i reloaded firmware and put right value for power supply 2 instead of 1 end everything working find:))))\
just finish xyz test cube came out great:))) ty all

i cant find anything that say turn off bed or anything like it:((

cura 4.7

Hi , i bought a rostock v2 used already assemble whit he280 hot end everything works, not fine tune yet but work.... problem is after i start the print, the bed stop heating up ,it work if i just heat up bed it will stay at desire temp as long as printer is on, it happen when i start printing, is ...