Welcome to the SeeMeCNC Community

As it happens, I have searched the board quite a bit and I believe my numbers to be correct. I was just hoping someone could tell me for certain.... Are you using 20 tooth pulleys or 15? If you are using Marlin then you have to calculate your s/pmm. If you are using repetier then you enter the ...

As it happens, I have searched the board quite a bit and I believe my numbers to be correct. I was just hoping someone could tell me for certain....

For my first calibration and print I went with 106.67. With it set like that the z distance between nozzle while homed and printing surface that was reflected in the firmware after calibration more or less matched my physical measurement. My first print of the calibration cube is shorter than it is ...