https://www.youtube.com/watch?v=izTpyWeqkhA
buying this machine was a mistake.
Search found 3 matches
- Sat Jun 07, 2014 8:51 am
- Forum: Troubleshooting
- Topic: Unsolved Mystery. Weird Z0 behavior around build perimeter.
- Replies: 500
- Views: 350480
- Wed Aug 14, 2013 3:07 pm
- Forum: New Member introduction
- Topic: print bot Vs rockstock Max
- Replies: 14
- Views: 11861
Re: print bot Vs rockstock Max
movements not flat, hotend oozes & jams with pla, I have .012 raise of hot end out on the edges, so unless you lay down a shit load of plastic for your first layer - it won't print large diameters. It makes that first layer a bitch. Heat bed is hot in the middle and is 20 deg c cooler on out parts ...
- Sun Jun 23, 2013 10:10 pm
- Forum: Troubleshooting
- Topic: Rostock Max Geometry Error?
- Replies: 6
- Views: 7489
Re: Rostock Max Geometry Error?
I have the exact same problems, Zero in front of towers & middle, z lifts -.018 between the towers on the outside of the radius. I have been trying to square the towers to the bed in both directions ( left-right & in-out ) having some success, I'm down to -.008 . The towers don't hold their position ...