Welcome to the SeeMeCNC Community

hi, i was looking into adapting Marlin for the RostockMax especially to benefit from the autolevel capabilities. Attached is a patch on top of https://github.com/RichCattell/Marlin. what works: - steppers/direction - rambo board - smart-lcd - ext0 fan configured to heater-pin0 what needs more ...

The endstop screws handle the rotation of the plane of the build surface first and foremost. The rotations must all be correct for the bed to be level. Imagine drawing a "T" across the build platform. You start out at the X tower, then draw a line to the center of the platform, and that's the ...

hi, i did restart the rostock as normal today after yesterdays failure. But extruding material did not yield a reliable/good flow at all. Before when extruding into the air it was a consistent flow but now it was just thin curling material. After disassembling the hotend i've found that the inner ...

i changed the "extrusion multiplier" to .55/.63=.873

hi, i was attempting to print http://www.thingiverse.com/thing:67071 . I've used slic3r0.99+RepetierMax Firmware+RepetierHost and apparently the print is showing good quality initially. in total this are ~210 layers. i got ~180 correct layers and then something happened. process parameters (temp ...

hi, would be glad to get some input on my calibration snapshots. the used material is abs from fabber-parts.de (cheap but doesnt seem to be good quality). anyway, first i did run with the 0.5 single wall (slic3r, 1 perimeter,0% infill,.5 nozzle (officially - didnt really crosscheck but the filament ...

100 points go to Broose. i changed the cables and now the sdcard is recognized.

thanks
/uwe

hi,

i have tried the supplied 4GB SDHC from sandisc and an old 128M infineon card (i need to see if i find some others to test).

/uwe

hi, i'm running the rostock-max but cant get the sdcard access to work. the lcd works ok (i can control hings from the lcd and see the status) but i cant neither mount/umount/print from the sdcard. all i'm getting is an "sd init fail". the sdcard is formatted fat16 and works ok when inserted in a ...