Welcome to the SeeMeCNC Community

Have you seen this? http://reprap.org/wiki/Kossel#Automatic_bed_leveling_probe I had not seen that. It looks like the pin 10 which I have been working with is for the z tower not the z position. Thanks. Back from taking a look-see. There was some information I can use. What I learned: It looks like ...

I've looked and can't find a working method. I have had some success getting a new zero location but not by using the information provided. For one thing Repetier configuration.h 0.91 has it on pin 63. My RAMBo uses pin 10 for the z_min. It ain't never gonna work that way unless there is something I ...

Here is a spread sheet with a partial list of gcodes.

updated
2014.05.03

I had a problem with the end stop microswitches being loose. Tighten those and then try again. Good luck.

[img]http://www.hackmaine.org/turtle[/img]

This is my Rostock Max set up at the Maine Discovery Museum. You will have to refresh to see the latest image. (Firefox has an autorefresh addon.)

Hairy Situation.jpg We have not conquered the art of keeping the first layers from curling up. I figured the extruder must have caught on one of the edges and lost its bearings (if you know what I mean.) Some arms were warped but straighten right out with the use of a wet paper towel heated in a ...

Maine Hacker Club members assembling Rostock MAX.
[youtube]http://www.youtube.com/watch?v=M-vhtJHRTxU[/youtube]