RepRapFirmware 1.17RC1 available

[dc42]

Release Candidate 1 of RRF 1.17 is now available on GitHub. The list of changes since 1.16 is quite long and can been seen at https://www.duet3d.com/forum/thread.php?pid=5687#p5687. Of particular interest to delta printer owners is grid bed compensation, which is now fully implemented including re-loading the height map from file and tapering the compensation to zero over a specified height. Also the delta auto calibration and heater auto tune parameters are now saved to config-override.g by M500.

Make sure you read the upgrade notes at https://github.com/dc42/RepRapFirmware/ ... /WHATS_NEW before upgrading.