rocket print

[cambo3d]

bad side,

better side,

anyway to improve quality of this print?

[untitled86]

What caused that bad side?

[cambo3d]

bowden extruder, thats what it does during layer changes, haven' been able to figure out how to tune that out yet.

[DaGroundZero]

You might try changing your slicer settings to do a random starting point. I had that same issue but it was much better when I changed it. I took it off to test it again, and I'm seeing the issue again.

[cambo3d]

[quote=" I took it off to test it again, and I'm seeing the issue again.[/quote]

??? are you saying it didn't solve your problem?

[DaGroundZero]

I was just saying it seems to help my prints when I have that option checked.

[untitled86]

It's got to be more than the random start option. I've got that checked, my part is perfect except for this issue. It always screws it up going up on the Z axis. I'd love to know how to fix it.

[cambo3d]

kisslicer has a seam setting that ranges from 0-1, i think this is what i need to adjust to minimize that seam. currently it was set to 1, i'm going to try 0 and see what happens.