Hi guys,
Looking to add the probe to my rostock v2 currently using 713 mount and e3d v6. How hard is it to wire up?
any tips would be great.
adding the probe board to a v2
-
deadpool66
- Printmaster!
- Posts: 68
- Joined: Tue Jul 26, 2016 8:19 pm
-
mattster98
- Plasticator
- Posts: 7
- Joined: Thu Apr 16, 2015 10:25 pm
Re: adding the probe board to a v2
Just finished hooking this exact setup up. I added the 713maker mount at the same time and got the mount for the accelerometer board from them.
Not super hard - followed these instructions: https://seemecnc.dozuki.com/Guide/Rosto ... de/49#s402
For whatever reason those instructions were challenging for me to follow, but I got it done. Obviously that doesn't address the exact steps with the E3D extruder, but it wasn't that hard to work out where to attach things.
Unfortunately I'm having an issue that I haven't yet worked through.. see my post in the "Troubleshooting" section.
Not super hard - followed these instructions: https://seemecnc.dozuki.com/Guide/Rosto ... de/49#s402
For whatever reason those instructions were challenging for me to follow, but I got it done. Obviously that doesn't address the exact steps with the E3D extruder, but it wasn't that hard to work out where to attach things.
Unfortunately I'm having an issue that I haven't yet worked through.. see my post in the "Troubleshooting" section.