Decoupling Error

Having a problem? Post it here and someone will be along shortly to help
Post Reply
Fox
Noob
Posts: 1
Joined: Sat Jan 27, 2018 8:17 pm

Decoupling Error

Post by Fox »

I have a K280 printer and I printed out two prints when I ran into a decoupling error. I checked to see if there were any volts going through the place where the wire connected to the board (there were about 24v) and checked if the temp sensor was working; it did.

I got a hair dryer and blew hot air on the temp sensor as I told the heater to heat to 200C. So I basically tricked it to believe the heater was heating up, so it continued to heat itself instead of giving me an error (“dec” on the LED screen).. This should indicate that there isn’t anything physically wrong?

I am dumbfounded as to why. I did buy a spare one but I don’t know why it’s giving me this error.
Attachments
Capture.JPG
User avatar
rootboy
Printmaster!
Posts: 273
Joined: Wed Mar 12, 2014 2:34 am
Location: Lewisburg, Tennessee

Re: Decoupling Error

Post by rootboy »

Are you sure that you don't have the hotend and bed heater wires swapped?

https://forum.repetier.com/discussion/1 ... for-safety
Post Reply

Return to “Troubleshooting”