No matter what I print, this happens on the back side of the print. Is this a sign of one of the arms binding? if so Which tower would cause that?
And what about all of the strings, Do I need to run even hotter?
By the way, I'm running pla and I have to turn it all of the way up to 230 to get good flow and I have checked the inside temp of my nozzle and its nearly dead on. The power supply seams to struggle to get up over 220. I have ran the pid several times and the numbers are much different every time. I do have a peek fan and and the pid was set with it on.
I included A pic of a pyramid I ran on my replicator at 80mm speed on the first try.
I would love to see that on my Rostock...
