"adjustment screw to the right to raise the
platform and to the left to lower the platform."
https://dl.dropboxusercontent.com/u/16409184/blah.png
depending how you look at the screwdriver top, for me it was the opposite all goes wrong.. its how i been taught by calibrating stuff in cars and bolts, however..here in sweden.. dont know its the same all over europe or its just here.. but...
"In order to lower the nozzle, you'll need to decrease the value in PRINTER_RADIUS.
In order to raise the nozzle, you'll need to increase the value in PRINTER_RADIUS."
well, for me it was the opposite.. or i just did as it said in the firmware.
now im gonna try to print out the first one.. however.. i dont want want to fuck this up.. so... what should i print..? what temprature? and what kind of setup in repetier host..
i missing a "first print section" and "daily service / week service section"... and this forum is like swamp, no stickys anywere...
i mean.. this is like a new car!
thanks for suggestions..
