tricklaser arms printing over sized?

[bplemmons]

I'm printing the 25 mm cube oversize with new trick laser arms. it is a new machine and I do have the pulleys set to 20 (plastic)
Do I need to change delta radius in the firmware like I did on the magnets?

[Broose]

If your prints are slightly oversized on the X and Y axes with the new arms, then you should try increasing DELTA_DIAGONAL_ROD slightly and checking again. DELTA_RADIUS is for dealing with doming on the Z axis (center of platform is higher or lower than outer edges).

[cambo3d]

was the magnetic conversion still giving you problems?

[bplemmons]

It is a different machine...

I haven't seen the heat shield yet, when did you send it Cambo?

[cambo3d]

It is a different machine...

I haven't seen the heat shield yet, when did you send it Cambo?

I didn't, you never sent payment. I figured you changed your mind.

[bplemmons]

Check your email..... My bad,sorry. Still want it

[bplemmons]

http://store.makerstoolworks.com/motion ... t2-pulley/

found this, 12.7? is this right?

[cambo3d]

the firmware listed on the downloads page of the seemecnc website is already setup for 20 tooth pulleys. try that.

that 12.7 diameter isn't relevant for the delta drive 0 type, according to the firmware.