I need help on a
EZStruder Cold End Kit
It says it can be used for 3 or 1.75mm filament but the hole is much too small for 3mm. Do I have to drill it out? How about the guide to the cold end, do I have to bore this out as well?
EZStruder Cold End Kit
Re: EZStruder Cold End Kit
I am talking about the bowden adapter.
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: EZStruder Cold End Kit
It works with a 3mm hotend as a direct drive see the video at http://reprap.org/wiki/EZStruderkdoney wrote:I need help on a
EZStruder Cold End Kit
It says it can be used for 3 or 1.75mm filament but the hole is much too small for 3mm. Do I have to drill it out? How about the guide to the cold end, do I have to bore this out as well?
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”