Hello. I am a new 3d printer builder. I am building for a friend since I have been building cnc machines for about 20 years. I need help on a
EZStruder Cold End Kit
It says it can be used for 3 or 1.75mm filament but the hole is much too small for 3mm. Do I have to drill it out?
Kevin
Hello and help from Florida
Re: Hello and help from Florida
I am talking about the bowden adapter.
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Hello and help from Florida
Welcome to the Forum!
I answered your question in your other post but I will add to it here.
The EZStruder supports 3mm hotends as a direct drive to a groove mount hotend but does not support 3mm bowden connections.
There is a video at http://reprap.org/wiki/EZStruder.
I answered your question in your other post but I will add to it here.
The EZStruder supports 3mm hotends as a direct drive to a groove mount hotend but does not support 3mm bowden connections.
There is a video at http://reprap.org/wiki/EZStruder.
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”