Slicer errors?

[Jimustanguitar]

Has anybody else gotten this error while using the Slic3r built into Repetier Host?

[img]http://i.imgur.com/ht8DxIm.jpg[/img]

[Durandal]

I got this error when I turned the nozzle Diameter down to .1mm.

[foshon]

Yeah, slic3r failed, but RH is not programmed to pick that up.

[summyman]

I just updated to the newest version of Repetier Host, VO.95D and I get this same error message when I try to slice with Slic3r. Did you figure out how to resolve this error? Any help will be appreiciated.

[SDI]

i was offered the RH update today and declined due to my deep set, inherent fear of updates

[JolietDelta]

Hi!

I get this message after provoking an error in slic3er. Seems that RepHost has changed its kind of error handling. The faulty part isn't RepHost but a unsuccessfull slic3r session.
Strange: objects/settings which couldn't be sliced with the command-line edition of slic3r (which is used by RepHost), didn't fail with the UI-version of slic3r.

Besides that - I had no problems after updating RepHost.

-Jens

[foshon]

I get it now that I've updated, yet Slic3r works very well. It's an integration issue of some kind. The cool kids are talking about it Repetiers Reprap forum sub-section.