First Prints... YAY! I'm printing!

[neurascenic]

I attempted this print with a 15% infill! and it too looked great. This time, I actually had a little issue at the. Bottom, but I am fairly confident that it was a coling issue, as imam still not running with a layer fan on PLA.

Took lots of plastic just to figure out it isn't an issue after all, yet still a good thing to know.. No complaints here.

Topic is officially dead.

Thanks!

[DavidF]

I attempted this print with a 15% infill! and it too looked great. This time, I actually had a little issue at the. Bottom, but I am fairly confident that it was a coling issue, as imam still not running with a layer fan on PLA.

Took lots of plastic just to figure out it isn't an issue after all, yet still a good thing to know.. No complaints here.

Topic is officially dead.

Thanks!

that heated build chamber is looking better all the time.....

[neurascenic]

I'm Working on one, though it seems queer to me that I need to cool and heat at the same time.

Anybody know what the theory is? Each makes sense individually, just wondering about the combination.

[DavidF]

HA!! and top that with cool only what needs to be cooled, and heat what only needs to be hot...