Knob on EZstruder

[Eaglezsoar]

Can one of you Cad experts create an STL of the gear type knob that is on the EZstruder and size the
hole so it would fit on the LCD display?
I really like that design and would like to make them for my LCDs. I can't even draw a straight line
in Cad so I am looking to someone on the forum to create this as an STL. I have searched Repables
and Thingiverse and that knob is not to be found.

[bubbasnow]

this one?

[Eaglezsoar]

THAT'S IT! THANK YOU! Where did you find that part?

[bubbasnow]

THAT'S IT! THANK YOU! Where did you find that part?

i think thingiverse originally, but i pulled it out of my stl folder

[Eaglezsoar]

THAT'S IT! THANK YOU! Where did you find that part?

i think thingiverse originally, but i pulled it out of my stl folder

You must have a good size STL folder, I appreciate you finding that for me.

[bvandiepenbos]

That "knob" seeme uses on the ezsttruder is acuatly a gear from the original steves extruder, they reused it.
just a little trivia for ya.

[Eaglezsoar]

That "knob" seeme uses on the ezsttruder is acuatly a gear from the original steves extruder, they reused it.
just a little trivia for ya.

That's nice to know. I have a couple of those extruders and they may come up missing some gears!

[geneb]

The gear is also included with the new v2 kits. (as well as the LCD knob!)

g.

[Eaglezsoar]

The gear is also included with the new v2 kits. (as well as the LCD knob!)

g.

Cool! I like that little gear as a knob.