Well I finally got around to finishing up my Rostock max.
After more than my share of problems, I've got it running reasonably right now.
I'll be using this for fun, learning and prototyping some part for my Chopper.
By day I am an IT Guy, have been for over 30yrs.
Off hours if its nice I can usually be found on one of my custom choppers headed down the road.
New Guy from Jersey
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: New Guy from Jersey
Welcome to the forum!
I hope you are enjoying your Rostock Max and we can help you with any questions and
from the sounds of it you can help us answer questions also.
Be careful but have fun on your chopper and most of all,
Happy Printing!
I hope you are enjoying your Rostock Max and we can help you with any questions and
from the sounds of it you can help us answer questions also.
Be careful but have fun on your chopper and most of all,
Happy Printing!
-
McSlappy
- Printmaster!
- Posts: 800
- Joined: Wed Dec 11, 2013 9:11 pm
- Location: Queensland, Australia
- Contact:
Re: New Guy from Jersey
Got any pics of your choppers?
Oh and welcome.
Oh and welcome.
I loved my Rostock so much I now sell them in Oz 
Re: New Guy from Jersey
Welcome! I was out in the garage working on my bike today. If eternal winter ever goes away, I'll be spending some time behind bars
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: New Guy from Jersey
We'll bail you out.johnoly99 wrote:Welcome! I was out in the garage working on my bike today. If eternal winter ever goes away, I'll be spending some time behind bars