I was looking around at the various means of controlling my 3D printer when I came across this: http://www.ebay.com/itm/1-set-x-5-axis- ... 3a78f33b46
Definitely a lot cheaper than a TB6560 controlled board, but I'm wondering if the power output power is enough.
Any thoughts?
Alternative Driver board?
Re: Alternative Driver board?
That's ONLY a logic interface board, it's incapable of driving any kind of motor directly. The separate drivers for each motor are not included and need to be purchased to have a working solution.
Re: Alternative Driver board?
Ah, ok that would make sense given the lower power consumption.
Re: Alternative Driver board?
Hi everybody,
I dig up this old post to say that I'd devellopped my own board.
this is a very simple board, based on PIC programmed in C.
its design, as the SW is available on my web site.
Google translator will surely helps non french readers.
I dig up this old post to say that I'd devellopped my own board.
this is a very simple board, based on PIC programmed in C.
its design, as the SW is available on my web site.
Google translator will surely helps non french readers.
https://m.facebook.com/FR3Dprint" onclick="window.open(this.href);return false;
https://sites.google.com/site/fr3dprint/" onclick="window.open(this.href);return false;
https://sites.google.com/site/fr3dprint/" onclick="window.open(this.href);return false;