MatterControl seems to just stop at the point where status is "saving intermediate file..." I've been waiting for an hour now and nothing......
Any Ideas?
Saving intermediate file..... FOREVER
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Saving intermediate file..... FOREVER
I have had the same thing happen. I assume there is a bug in the software which will be fixed as the software is revised.bglandon wrote:MatterControl seems to just stop at the point where status is "saving intermediate file..." I've been waiting for an hour now and nothing......
Any Ideas?
Re: Saving intermediate file..... FOREVER
I exchanged some e-mails with MatterControl support on this.
The immediate fix is to switch to CuraEngine for the Slicer.
I did a couple of experiments with Slic3r. First, I upgraded from RC3 to Stable. That did not fix the "Saving Forever Issue". Second, I used Slic3r independent of MatterControl. It sliced and wrote Gcode in under two minutes. The printer ran the job just fine. Seems to be an interface between MatterControl and Slic3r.
The immediate fix is to switch to CuraEngine for the Slicer.
I did a couple of experiments with Slic3r. First, I upgraded from RC3 to Stable. That did not fix the "Saving Forever Issue". Second, I used Slic3r independent of MatterControl. It sliced and wrote Gcode in under two minutes. The printer ran the job just fine. Seems to be an interface between MatterControl and Slic3r.