steppers skipping by theselves?

[tom10122]

so, my resistors went and I was waiting for new ones, popped them in and started printing again and I had skew! Didn't touch any thing else, the previous print was great with no skew, I can hear the steppers making a thud, sorta like , dun dun dun , is this the steppers skiping? They did it even with no belt on them(FYI it's only the x and y steppers

[johnoly99]

Tom, just emailed you back. Check the jumper mods out. Thats the source of your issues im sure of it

[tom10122]

I think I'm gonna redo the jumper mod and I'll get back to you

[tom10122]

worked for two prints now the problem came back, soldered the jumpers, thinking it was a bad connection but the still skip