Animal and Criter Prints

[PartDaddy]

Brian V shown this at our local maker meeting and I had to print one. From thingiverse, I chose the thin wall snake and single wall thickness. Flexible and interesting.

[michaellatif]

Cool, what are you printing now? Looks like a frog?

[PartDaddy]

The Frog is from thngiverse too. I printed these tonight. As well as several over things. I was printing on a microns wire heated bed. The aluminum is 1/8" (3mm) thick. It did not get hot enough, but did make a difference. I was also test printing the ABS on the clear plastic sheet. I'm still trying to figure out how to get even surface finish on the frog as the print angle changes shallow as the layers step up.

Frog print

Frog during print

Frog done!

[bvandiepenbos]

Brian V shown this at our local maker meeting and I had to print one. From thingiverse, I chose the thin wall snake and single wall thickness. Flexible and interesting.

2012-05-06_20-24-31_312.jpg

That is my favorite thing to print. Makes a great demo to amazed family and friends.

[bvandiepenbos]

That frog is cool Steve.
Another one for the to-print list.

[PartDaddy]

Once I saw you print the snake, Brian, I had to print it. My prints aren't quite as nice as your prints (yet). Lot of fun to show that one. I have other "living hinge" ideas. We need to punch a hole through it and thread some dental floss through it and we'll have motion!

[Paul Kelley]

[img]http://forum.seemecnc.com/download/file ... &mode=view[/img]

What type of filament material was used for this?

[johnoly99]

Paul, that was printed with 3mm abs

[Fiero2M6]

Lookin good. I like to use the frog for experimenting with layer heights.

Is the black shell on the front of your extruder a fan case?

[johnoly99]

Lol, not a fan case, just a small skull.