onyx bed in kit is diff from manual picture.

edwardjanderson · Post by **edwardjanderson** » Fri May 02, 2014 7:07 pm

the pics show how / where to solder the resister and LED but my solder pads are different. anyone have this happen?

Post by **geneb** » Fri May 02, 2014 7:08 pm

Are you looking at the most recent (1.40 as of 05/02/14) manual?

g.

edwardjanderson · Post by **edwardjanderson** » Fri May 02, 2014 7:16 pm

I am building to the manual on download page " Rostock MAX v2 (kits shipped AFTER appx. 2/22/2014)" is this the correct one?

i will upload a pic in a moment.

edwardjanderson · Post by **edwardjanderson** » Fri May 02, 2014 7:20 pm

the small pads on left are for the LED, I'm just not sure which side of the LED goes to which pad also I have no idea where to put the resister.

edwardjanderson · Post by **edwardjanderson** » Fri May 02, 2014 8:13 pm

i found the manual you mention above. looks like I need to resolder my thermistor. I'm back on track though.

Welcome to the SeeMeCNC Community

onyx bed in kit is diff from manual picture.

onyx bed in kit is diff from manual picture.

Re: onyx bed in kit is diff from manual picture.

Re: onyx bed in kit is diff from manual picture.

Re: onyx bed in kit is diff from manual picture.

Re: onyx bed in kit is diff from manual picture.