I read it a couple of weeks back, it was a pretty long thread with a lot of information regarding the Rev3 Onyx failing the PID autotune and taking a long time to heat up.
Anyone know where it is? I've looked through the troubleshooting for pages but havn't run across it and the site search is... well... broken. Even used google's site search but I'm sure I'm not using the syntax that was used in the thread because I cannot find it.
Help me Oobiedoob Benubi you're my only hope.
Where was the thread regarding PID fail with Onyx heated bed
-
McSlappy
- Printmaster!
- Posts: 800
- Joined: Wed Dec 11, 2013 9:11 pm
- Location: Queensland, Australia
- Contact:
Where was the thread regarding PID fail with Onyx heated bed
I loved my Rostock so much I now sell them in Oz 
-
McSlappy
- Printmaster!
- Posts: 800
- Joined: Wed Dec 11, 2013 9:11 pm
- Location: Queensland, Australia
- Contact:
Re: Where was the thread regarding PID fail with Onyx heated
Of course... I spend 45 minutes looking for it and then find it just after I post....
http://forum.seemecnc.com/viewtopic.php?f=37&t=5206
http://forum.seemecnc.com/viewtopic.php?f=37&t=5206
I loved my Rostock so much I now sell them in Oz