[Solved] My first print failed - what's going on?

[jeffhuber]

[img]http://i.imgur.com/WAAeX92.jpg[/img]

Is the hot end too close to the board?

or is the plastic not sticking well enough?

more elmers disappearing glue?

thanks for the help!

[Polygonhell]

Your Hotend is too low, looks like it's pretty much scraping along the build plate, this will cause the espxtruder to eat the filament.
When you set your Z Height, everything needs to be up to temperature.

[jeffhuber]

That solved it! Thanks Polygonhell!