Best slicing software?

tom10122 · Post by **tom10122** » Fri Jan 18, 2013 7:12 pm

Repetier is too involved for me, I have slic3r but want to try something new. What's out there?

Polygonhell · Post by **Polygonhell** » Fri Jan 18, 2013 9:31 pm

tom10122 wrote:Repetier is too involved for me, I have slic3r but want to try something new. What's out there?

The only slicers I'd use at this point are KISSlicer or Cura.

v8tony · Post by **v8tony** » Fri Jan 18, 2013 10:52 pm

I use Cura for just about everthing now... Kisslicer is also very good, I gave up on Slicer long ago...

tom10122 · Post by **tom10122** » Fri Jan 18, 2013 11:06 pm

thanks guys

tom10122 · Post by **tom10122** » Sat Jan 19, 2013 10:17 am

I'm getting hung up with cura, it generates m-codes that don't work with EMC2 any ideas?

Welcome to the SeeMeCNC Community