Cheapo Hand-held spool holder

User-Generated tips and tricks for the Rostock Max, Orion, H1.1, or H1 Printers
Post Reply
User avatar
teoman
ULTIMATE 3D JEDI
Posts: 1770
Joined: Sat May 24, 2014 5:43 pm

Cheapo Hand-held spool holder

Post by teoman »

I had to unwind and wind my spool. So I was looking for a rod to insert in to it to be able to roll it on there.

At that moment i saw the empty handle of those sticky clothes cleaner rolls that you can buy from IKEA, they are wonderful for removing cat hairs etc. And it fit my spool rather nicely.

The spool also has a small hole in the side, i only needed to unwind a relatively short amount, but if it were longer, i would definitely put a bolt through there so i could wind it much faster.
Attachments
Spool holders
Spool holders
spool from side
spool from side
spool from top
spool from top
When on mobile I am brief and may be perceived as an arsl.
Post Reply

Return to “General Tips 'N Tricks”