Onyx Rev7

[bauf]

I guess i posted in the wrong section, anyways.. So i got my max2 kit today and i'm @ 5C in the manual. But the manual doesnt include the rev7. On the bed i can only see 1 LED slot and 1 Resistor slot, but i got 2 LEDs and 2 Resistors.. so i guess they were just included in the kit in case i got a rev6,or what?

oh,and another thing in the manual; Strip about 1/8” from the white & green wires. These are used as the power wires for the hot
end LED and are installed as shown below. Make sure you've got the green wire attached to the “+”
pad and the white wire attached to the "-".

here's a picture of it. I don't have that that "HOT - + " tabs on my rev7 bed. So what do i do with the green and white cable then?

[bauf]

And this is what i've done so far. What are those tiny holes for at the top? There are 7 at the top and 7 right over the Thermistor hole.
oh and i don't have kapton tape yet,it's being shipped,so i'm gonna put some kapton on there when i get it.

[Mac The Knife]

The little holes are for passing the power to the other side of the bed.