Adding a second layer fan to Orion

deager4 · Post by **deager4** » Mon Nov 24, 2014 11:17 am

IS there any way to add a second layer fan to the Orion? Just wondering. Thanks.

Post by **Eaglezsoar** » Mon Nov 24, 2014 11:39 am

deager4 wrote:IS there any way to add a second layer fan to the Orion? Just wondering. Thanks.

You can print another fan shroud for the layer fan: http://repables.com/r/212/
Click the arrow on the right of download to get just the stl.

You also will need the fan which is here: http://seemecnc.com/collections/parts-a ... blower-fan

guanu · Post by **guanu** » Mon Nov 24, 2014 11:42 am

here is the current version of the blower shroud...

Guanu

deager4 · Post by **deager4** » Fri Dec 05, 2014 11:55 am

Thanks how would I wire the second fan?

Post by **Eaglezsoar** » Fri Dec 05, 2014 12:09 pm

deager4 wrote:Thanks how would I wire the second fan?

The second fan is wired in parallel with the first fan.

deager4 · Post by **deager4** » Fri Dec 05, 2014 1:58 pm

Could I in theory wire three of the together without drawing too much current? Thanks.

Mac The Knife · Post by **Mac The Knife** » Fri Dec 05, 2014 2:03 pm

deager4 wrote:Could I in theory wire three of the together without drawing too much current? Thanks.

Yes you can, I currently run three hooked together in parallel.

Jimustanguitar · Post by **Jimustanguitar** » Fri Dec 05, 2014 3:30 pm

I run 3. Mainly for symmetry / even coverage.

Fans require very little power, so you're fine.

Welcome to the SeeMeCNC Community