Picture showing Z-height calibration results

[jarek319]

Hi everyone!

I saw a picture on here a while back which showed a few lines being printed after setting the Z height above and below the optimal distance, as well as an example of a perfectly calibrated zheight. I didn't save the picture however...

After searching for a couple of hours, I couldn't find the picture again. I'm hoping one of the regulars posted it and can share it with me? My first layers are adhering almost too well, and they're coming out a bit squished, so I wanted to compare them to the lines in the picture and see where my calibration stands...

[KAS]

The assembly manual has 5 images on page 262 that shows something similar, if that helps.

[jarek319]

Ah, this looks like where that picture came from. Thanks!