Infill gaps and non-circular holes

McSlappy · Post by **McSlappy** » Wed Jan 21, 2015 9:48 pm

Is this a belt issue?

[img]http://i.imgur.com/64qXEJS.jpg?1[/img]
[img]http://i.imgur.com/a9VQIzb.jpg?1[/img]

It's actually one of two issues I'm having right now, the second is that I'm getting wavy outer walls - and I've noticed it's less of an issue with smaller objects, perhaps an outer perimeter issue?

Thoughts? Throw them at me!

Holy1 · Post by **Holy1** » Wed Jan 21, 2015 9:53 pm

Definitely a mechanical issue. Had a similar problem like that myself not long ago.

McSlappy · Post by **McSlappy** » Wed Jan 21, 2015 11:33 pm

And how did you sort it out?

Khalid Khattak · Post by **Khalid Khattak** » Thu Jan 22, 2015 2:20 am

i also want to know how you sort it out?

teoman · Post by **teoman** » Thu Jan 22, 2015 2:58 am

I had a similar problem lately. Not sure if i solved it because my ssrs are fried. But my cheapskates were very lose.

McSlappy · Post by **McSlappy** » Thu Jan 22, 2015 8:37 pm

I checked mine again, and they're all good. Arms are good, joints are good.

DavidF · Post by **DavidF** » Thu Jan 22, 2015 10:08 pm

What did the layers look like in the slicer? Try adding another perimeter and see what happens.

Welcome to the SeeMeCNC Community

Infill gaps and non-circular holes

Infill gaps and non-circular holes

Re: Infill gaps and non-circular holes

Re: Infill gaps and non-circular holes

Re: Infill gaps and non-circular holes

Re: Infill gaps and non-circular holes

Re: Infill gaps and non-circular holes

Re: Infill gaps and non-circular holes