First Build, LCD is not powering on.

Having a problem? Post it here and someone will be along shortly to help
Post Reply
3amjosh
Printmaster!
Posts: 38
Joined: Fri Jan 23, 2015 6:53 pm

First Build, LCD is not powering on.

Post by 3amjosh »

I've just finished the build that I started last Monday, and I've taken my time and been super slow. You can imagine the level of discouragement I got when I powered on and the LCD didn't light up. I've reseated the cables and connections on the board but still no go. Any other tips or ideas?
Top
BenTheRighteous
Printmaster!
Posts: 695
Joined: Fri Nov 07, 2014 9:38 am

Re: First Build, LCD is not powering on.

Post by BenTheRighteous »

What fans run when you turn on the printer? Psu? Rambo?
nitewatchman wrote:it was much cleaner and easier than killing a chicken on top of the printer.
Top
3amjosh
Printmaster!
Posts: 38
Joined: Fri Jan 23, 2015 6:53 pm

Re: First Build, LCD is not powering on.

Post by 3amjosh »

Both fans are running.
Top
3amjosh
Printmaster!
Posts: 38
Joined: Fri Jan 23, 2015 6:53 pm

Re: First Build, LCD is not powering on.

Post by 3amjosh »

BenTheRighteous wrote:What fans run when you turn on the printer? Psu? Rambo?

Cables on board were upside down. All good now!
Top
Post Reply

Return to “Troubleshooting”