When I go to the link provided in the manual and download the Layer Fan Shroud for V2, it's an invalid STL file. I see comments on that site where others are experiencing the same issue. I've found an older version but it doesn't have enough clearance for the V2 version of Printer.
Does anyone have the correct Layer Fan Shroud STL file that you can post?
Thanks in advance!
Layer Fan Shroud for V2 STL issue
-
mvansomeren
- Printmaster!
- Posts: 207
- Joined: Mon Jan 26, 2015 1:18 pm
- Location: Northridge, CA
Layer Fan Shroud for V2 STL issue
___________________________________________________
Proud owner and builder of the Rostock MAX V2
Corsair RM750 PSU, Stepper Motor Dampers, Stock Hotend.
Proud owner and builder of the Rostock MAX V2
Corsair RM750 PSU, Stepper Motor Dampers, Stock Hotend.
-
Earthbound
- Printmaster!
- Posts: 458
- Joined: Sun Sep 07, 2014 2:39 am
Re: Layer Fan Shroud for V2 STL issue
Here is the one I like best.
"Trust no quote from the Internet." - Abraham Lincoln
-
mvansomeren
- Printmaster!
- Posts: 207
- Joined: Mon Jan 26, 2015 1:18 pm
- Location: Northridge, CA
Re: Layer Fan Shroud for V2 STL issue
Thank you so much! I'm not sure why it hasn't been corrected on the website since it has apparently been a problem for a few months now.Earthbound wrote:Here is the one I like best.
___________________________________________________
Proud owner and builder of the Rostock MAX V2
Corsair RM750 PSU, Stepper Motor Dampers, Stock Hotend.
Proud owner and builder of the Rostock MAX V2
Corsair RM750 PSU, Stepper Motor Dampers, Stock Hotend.