Hey guys,
I built a RoStock Max V2 for my boss over an internship last summer. My printer back at home is different model. Anyway, I am back setting up a job for myself with my boss and working on his printer. Since I was here last you guys switched over to Matter Control. I've installed it and connected our printer, but I can't quite figure out how to load the presets and get our printer running. Is there some instructions for this somewhere?
(Solved) Matter Control Help
-
FDM_Process
- Printmaster!
- Posts: 44
- Joined: Fri Jun 20, 2014 5:32 pm
(Solved) Matter Control Help
Last edited by FDM_Process on Wed Mar 11, 2015 12:21 pm, edited 1 time in total.
-
mvansomeren
- Printmaster!
- Posts: 207
- Joined: Mon Jan 26, 2015 1:18 pm
- Location: Northridge, CA
Re: Matter Control Help
Download the Matter Control Pre-Configured Profiles from the SeeMeCNC website and then import them into the settings page.
The instructions are on page 243 of the manual:
http://download.seemecnc.com/rostockmax ... dition.pdf
The instructions are on page 243 of the manual:
http://download.seemecnc.com/rostockmax ... dition.pdf
___________________________________________________
Proud owner and builder of the Rostock MAX V2
Corsair RM750 PSU, Stepper Motor Dampers, Stock Hotend.
Proud owner and builder of the Rostock MAX V2
Corsair RM750 PSU, Stepper Motor Dampers, Stock Hotend.
-
FDM_Process
- Printmaster!
- Posts: 44
- Joined: Fri Jun 20, 2014 5:32 pm
Re: Matter Control Help
Thanks, my manual is pre Matter Control. I'll check out the new one.