I am considering adding two additional stock layer fans for a total of three. Can the thin wires included in the build (I think they are 22 AWG) handle the current for three stock layer fans?
Thanks.
Can the stock wiring handle 3 stock layer fans?
-
EL Cuajinais
- Printmaster!
- Posts: 96
- Joined: Wed Feb 18, 2015 9:09 am
Re: Can the stock wiring handle 3 stock layer fans?
Yes. I have three fans all hooked up in parallel with a single quick disconnect to the stock wires. It's been fine for over 1,000 hours of printing.
*not actually a robot
-
EL Cuajinais
- Printmaster!
- Posts: 96
- Joined: Wed Feb 18, 2015 9:09 am
-
lumpy_potato
- Printmaster!
- Posts: 36
- Joined: Tue Feb 17, 2015 11:32 pm
Re: Can the stock wiring handle 3 stock layer fans?
Did you use the SeeMeCNC blower or another model?bot wrote:Yes. I have three fans all hooked up in parallel with a single quick disconnect to the stock wires. It's been fine for over 1,000 hours of printing.
-
bvandiepenbos
- Printmaster!
- Posts: 923
- Joined: Thu Apr 05, 2012 11:25 pm
- Location: Goshen, IN
- Contact:
Re: Can the stock wiring handle 3 stock layer fans?
3 fans is no problem with stock wiring.
~*Brian V.
RostockMAX v2 (Stock)
MAX METAL "ShortyMAX"
MAX METAL Rostock MAX Printer Frame
NEMESIS Air Delta v1 & v2 -Aluminum delta printers
Rostock MAX "KITT" - Tri-Force Frame
GRABER i3 "Slim"
RostockMAX v2 (Stock)
MAX METAL "ShortyMAX"
MAX METAL Rostock MAX Printer Frame
NEMESIS Air Delta v1 & v2 -Aluminum delta printers
Rostock MAX "KITT" - Tri-Force Frame
GRABER i3 "Slim"