glueing PLA to ABS
-
10kvclockman
- Plasticator
- Posts: 13
- Joined: Sun Jul 12, 2015 1:03 am
glueing PLA to ABS
Hi, I have created some PLA gears and have just printed some ABS hubs. What bonding can I use to join them. I have attached the stl of the two components but they are made of two different plastics, any ideas?
- Attachments
-
- Centre orrery gear with hub.stl
- this is the complete assembly
- (5.22 MiB) Downloaded 243 times
Re: glueing PLA to ABS
I've used good old 5 minute epoxy to great success. Rough up the surfaces a bit first.
Orion to Cartesian http://forum.seemecnc.com/viewtopic.php?f=59&t=7808" onclick="window.open(this.href);return false;
-
10kvclockman
- Plasticator
- Posts: 13
- Joined: Sun Jul 12, 2015 1:03 am
Re: glueing PLA to ABS
Thanks I will give it a go, might try reprinting the gear with a hub as part of the assembly