Just a vase, because I could...

[AussieBlake]

Prometheus Hot end, TL CF arms, 0.25mm, 30mm/s, verbatim blue PLA.

Was happy with how it turned out, slowly learning all the in's and out's of the Max V2.

[Eaglezsoar]

A very nice vase and a great job!

[Agisis]

How tall is that? Looks about 7 inches?

[AussieBlake]

Yea mate its around 5 inches I think....The STL file was way smaller, I had to scale it up. Going to do another LARGER one.

[Eaglezsoar]

Do you find that the Prometheus Hot end works better than any other that you have used?

[AussieBlake]

Hi Eaglezsoar,

I had only used the stock hot end prior to upgrading to the all metal hot end. I got similar results. Essentially I upgraded so I could crank the heat a bit with some different filaments. Plus the Prometheus gets a pretty good rap.... The only issue I had was with a faulty collet and the filament would work the collet out of the top of the heatsink. Has since been rectified. I'm very happy with it, seems to hold temp a lot better than the stock hotend, very small fluctuations.

Cheers

Blake