WHAT WITCHCRAFT IS THIS?!

[geneb]

MUAHAHAHAHAHAHA!


g.

[forrie]

What's this.. a new stock power supply?

[geneb]

I could tell you, but then I'd have to make you use a Makerbot.

g.

[Xenocrates]

If that's a 24V power supply stock, then I am very much want. Although I wish it weren't using a side panel for the plug, ETC, as I like clean lines, and also kinda planned to have a cable duct living on the two non-door sides.

[Mac The Knife]

The 12 volt supply works very well also. Alot better then a PC PSU. I cannibalized a powersupply for the back panel, for the power cord, and used the kits power switch to switch the mains.

[KAS]

Slots in the base are different from the v2.

Of course the images give away the instruction changes, specifically:
fig6.8-1 & fig18.4-5

[IMBoring25]

You can print covers for the LED PSUs. Designed appropriately, you can integrate them however/wherever you want. My Mendel came with one, then I designed one for a 30A upgrade and then one for a 24V upgrade

[bot]

I wish they made 24v ATX PSUs.