Replacement effector platform

[noahcoleman]

Hey all,
A mishap happened over Thanksgiving and the tab my layer fan attaches to has broken off (I'd post a picture, but the printer is at work and I'm at home right now). For now, I've just put it on one of the other two tabs, but I was wondering if there are any good replacement/upgrade effector platforms out there. I'm not really interested in moving to magnetic joints or anything, I'm just looking to replace my stock platform. Any suggestions would be greatly appreciated!

[Xenocrates]

If you haven't got the ball arms from SeemeCNC, then this is probably a good time to upgrade, providing you have the injection molded carriages. If you don't there's a stock effector in seemeCNC's store http://www.seemecnc.com/collections/par ... ostock-max, or you can get the carriages, and arms, as the arms come with a new effector platform.

If those don't catch your fancy, well, http://www.thingiverse.com/thing:859276 should work.

[Jimustanguitar]

You can always print one. Github.com/seemecnc

I'm working on my own design for a replacement effector right now. If the final version prints up the way I want it, I'll post about it tomorrow.

[gchristopher]

I printed PartDaddy's repable from here: http://repables.com/r/294/ as well as designing one to have a bigger center hole here http://www.thingiverse.com/thing:1083270. Both worked shockingly well for such a critical part. Once I adjusted horizontal radius, the print quality was back to better-than-I-can-measure.

TrickLaser sells a set of aluminum part replacements for the effector platform and carriage mounts: http://www.tricklaser.com/MAX-METAL-Pla ... L-PLAT.htm

[noahcoleman]

Thanks for all the quick replies, folks! I really appreciate it.