Inductive Proximity Probe Holder M8- Limit Switches

[Khalid Khattak]

Just designed the probe holder to be mounted on my new delta printer the OPTIMUS-4G

[Eaglezsoar]

Can we see some pictures of the whole printer?
It looks neat!

[waran14]

Can you share the config file for auto bed leveling procedure using Inductive probe ?

[Khalid Khattak]

Eaglezsoar... i shall share the video once uploaded.
[youtube]http://www.youtube.com/watch?v=0JmmbIUZOI4[/youtube]
waran14..i am using Marlin RC for autocalibration...

[Khalid Khattak]

Another-one..
[youtube]http://www.youtube.com/watch?v=hzhip47a ... e=youtu.be[/youtube]

[barry99705]

Eaglezsoar... i shall share the video once uploaded.
[youtube]http://www.youtube.com/watch?v=0JmmbIUZOI4[/youtube]
waran14..i am using Marlin RC for autocalibration...

Remove the s in https for youtube videos.

[Khalid Khattak]

Finally the 1st few prints on my home made 2nd delta printer OPTIMUS-4G. These are calibration prints.

[youtube]http://www.youtube.com/watch?feature=pl ... 4rHFN3G-4s[/youtube]

[barry99705]

Finally the 1st few prints on my home made 2nd delta printer OPTIMUS-4G. These are calibration prints.

[youtube]http://youtu.be/u4rHFN3G-4s[/youtube]

[youtube]http://www.youtube.com/watch?v=u4rHFN3G-4s[/youtube]

Also has to be the full link, not the shortened one. Don't know why, that's just how it is...

[Khalid Khattak]

Barry Thanks for the guidance..

[barry99705]

Barry Thanks for the guidance..

No problem. I cussed at the screen for a while figuring things out, so I try to spread the word!