Layer cooling fan shroud for E3D mounted under effector plat

[REV]

Hi all-

I've printed some of @626Pilot's 'Lucky Number 7' fan shrouds: http://www.thingiverse.com/thing:487768 but they seem to be made for a different, most likely older, effector plate. Provided you have the same setup as I do, what do you do for your layer cooling needs?

[img]

[/img]

[barry99705]

I'm currently printing this one.

http://www.thingiverse.com/thing:779135/#files

[barry99705]

Okay, I'm a dumbass. Should have looked in the parts bins before printing! Thought I still had that fan, guess not... So, I printed up this instead!
http://www.thingiverse.com/thing:1284511

It will fit the fan we already have. Installing tonight if I have time. Who am I kidding, it's friday, I'll have time!

[Eaglezsoar]

Okay, I'm a dumbass. Should have looked in the parts bins before printing! Thought I still had that fan, guess not... So, I printed up this instead!
http://www.thingiverse.com/thing:1284511

It will fit the fan we already have. Installing tonight if I have time. Who am I kidding, it's friday, I'll have time!

Thanks for mentioning that, I didn't know it was there.