Rambo board pin to control SSR

[duvdev]

Hello

I have a heatlamp to heat the air temo when printing ABS ans so...

I want to assign a pin from the board to the SSR that when in start to print i will a commang in the gcode to get that pin to high so the ssr will turn on the lamp and add a code to the end gcode to turn it of.

Is there a free pin for mr to use? and how can I use it?

thanks

[Xenocrates]

There are free pins to use. My suggestion is to use the case light. Discussion on finding it and using it can be found here:

http://forum.seemecnc.com/viewtopic.php ... ght#p80955

[duvdev]

thanks but I am using .91 software

[teoman]

There is GCODE to switch the pins on and off. You just have to find the pin.